APC Smart-UPS VT 30kVA 400V w/3 Batt Mod Exp to 4, Start-Up 5X8, Int Maint Bypass, Parallel Capable | SUVTP30KH3B4S

SUVTP30KH3B4S

APC Smart-UPS VT 30kVA 400V w/3 Batt Mod Exp to 4, Start-Up 5X8, Int Maint Bypass, Parallel Capable

·         Parallel-capacity capable

Increases total power capacity by using multiple uninterruptible power supplies simultaneously.

·         Parallel-redundant capable

Power the connected equipment with multiple uninterruptible power supplies to increase system redundancy

Smart-UPS VTFeatures & Benefits

Sustainability

·         EU CoC for UPS

Ensures that UPSs sold in the EU are highly efficient

Marketing Features

·         Manual maintenance bypass

Reduces installation costs by eliminating the need for an external mechanical bypass.

·         Network manageable

Provides remote power management of the UPS over the network.

·         Input power factor correction

Minimizes installation costs by enabling the use of smaller generators and cabling.

·         Hot-swappable batteries

Ensures clean, uninterrupted power to protected equipment while batteries are being replaced

·         Scalable runtime

Allows additional run time to be quickly added as needed.

·         Dual mains input

Increases availability by allowing the UPS to be connected to two separate power sources.

Total Cost of Ownership

·         Input power factor correction

Minimizes installation costs by enabling the use of smaller generators and cabling.

·         Intelligent battery management

Maximizes battery performance, life, and reliability through intelligent, precision charging.

·         Manual maintenance bypass

Reduces installation costs by eliminating the need for an external mechanical bypass.

·         Temperature-compensated battery charging

Prolongs battery life by regulating the charge voltage according to battery temperature.

Protection

·         Frequency and voltage regulation

Gives higher application availability by correcting poor frequency and voltage conditions without using the battery.

·         Safety-agency approved

Ensures the product has been tested and approved to work safely with the connected service provider equipment and within the specified environment.

·         Cold-start capable

Provides temporary battery power when the utility power is out.

Serviceability

·         Shippable with modules installed

Enables pre-installation UPS staging and testing and faster installation.

·         Automatic self-test

Periodic battery self-test ensures early detection of a battery that needs to be replaced.

·         Battery replacement without tools

Enables fast battery replacement, lowering Mean Time to Repair (MTTR).

·         Modular design

Provides fast serviceability and reduced maintenance requirements via self-diagnosing, field-replaceable modules.

Manageability

·         Network manageable

Provides remote power management of the UPS over the network.

·         SmartSlot

Customize UPS capabilities with management cards.

·         LED status indicators

Quickly understand unit and power status with visual indicators.

·         Programmable frequency

Ensures compatibility with different input frequencies.

·         Audible alarms

Provides notification of changing utility power and UPS power conditions

·         LCD display

Alpha-Numeric Display which displays system parameters and alarms.

·         InfraStruXure Manager Compatible

Enables centralized management via the APC InfraStruXure Manager.

Availability

·         Automatic internal bypass

Supplies utility power to the connected loads in the event of a UPS power overload or fault.

·         Generator compatible

Ensures clean, uninterrupted power to protected equipment when generator power is used.

·         Battery modules connected in parallel

Delivers higher availability through redundant batteries.

·         Scalable runtime

Allows additional run time to be quickly added as needed.

·         Dual mains input

Increases availability by allowing the UPS to be connected to two separate power sources.

Output

·         Output power capacity

24.0 KWatts / 30.0 kVA

·         Max Configurable Power (Watts)

24.0 KWatts / 30.0 kVA

·         Nominal Output Voltage

400V 3PH

·         Output Voltage Note

Configurable for 380 : 400 or 415 V 3 Phase nominal output voltage

·         Efficiency at Full Load

96.4 %

·         Output Voltage Distortion

Less than 5% at full load

·         Output Frequency (sync to mains)

47 - 53 Hz for 50 Hz nominal

·         Output Frequency (not synced)

50Hz +/- 0.1% for 50Hz nominal

·         Other Output Voltages

380, 415

·         Load Crest Factor

3 : 1

·         Topology

Double Conversion Online

·         Waveform type

Sine wave

·         Maximum Output Current

48

·         Bypass

Built-in Maintenance Bypass, Built-in Static Bypass

Input

·         Nominal Input Voltage

400V 3PH

·         Input frequency

40 - 70 Hz (auto sensing)

·         Input Connections

Hard Wire 5-wire (3PH + N + G)

·         Input voltage range for main operations

304 - 477V

·         Efficiency at Full Load

96.4 %

·         Other Input Voltages

380, 415

·         Maximum Input Current

41.0A

·         Input Power Factor at Full Load

0.98

Batteries & Runtime

·         Battery type

VRLA

·         Included Battery Modules

3

·         Typical recharge time

5hour(s)

·         Nominal Battery Voltage

+/-192 V (split battery referenced to neutral)

·         Battery Slots Empty

1

·         Expected Battery Life (years)

3 - 5

·         RBC Quantity

3

·         Extendable Run Time

1

·         Extended Run Options

APC-Smart-UPS-VT-30kVA-400V-w-3-Batt-Mod-Exp-to-4-Start-Up-5X8-Int-Maint-Bypass-Parallel-Capable

·         End of Discharge Battery Voltage

+/-154 V

·         Runtime

View Runtime Graph

View Runtime Chart

Communications & Management

·         Interface Port(s)

DB-9 RS-232 , Smart-Slot

·         Pre-Installed SmartSlot™ Cards

AP9631

·         Control panel

Multi-function LCD status and control console

·         Audible Alarm

Audible and visible alarms prioritized by severity

·         Emergency Power Off (EPO)

Yes

Physical

·         Maximum Height

1490mm , 149.0CM

·         Maximum Width

523mm , 52.3CM

·         Maximum Depth

842mm , 84.2CM

·         Net Weight

536.82KG

·         Shipping weight

568.18KG

·         Shipping Height

1643mm , 164.3CM

·         Shipping Width

650mm , 65.0CM

·         Shipping Depth

1062mm , 106.2CM

·         Color

Black

·         Units per Pallet

1.0

Environmental

·         Operating Temperature

0 - 40 °C

·         Operating Relative Humidity

0 - 95 %

·         Operating Elevation

0-999.9meters

·         Storage Temperature

-50 - 40 °C

·         Storage Relative Humidity

0 - 95 %

·         Storage Elevation

0-15000meters

·         Audible noise at 1 meter from surface of unit

55.0dBA

·         Online thermal dissipation

3685.0BTU/hr

·         Protection Class

IP 20